Build Tutorial Part 1: Make a moving mouth



Mark the vertical tabs with an X
Since this box is a cube it doesn't matter which tabs you choose to be the vertical tabs, so long as they are consistent on both the front and the back.

Remove the vertical tabs
After removing the tabs, set them aside. You will need them later.

Tape down the back
You can choose either side to the be back.


Design some eyes
Get creative! Make any eyes you want.

Locate the single arm and the single arm mount
Set all other servo components aside. If you choose to do any add-on features, you will the X servo horn.

Remove the existing servo horn
The set screw can be extremely tight.


Turn the single arm horn clockwise until it cannot turn anymore.

Calibrate the servo
This ensures that the servo is set to it's center position.










